.:4GB VERSUS 8GB:.
Gan ane punya macbook pro 13'inch 2011
specknya:
-processor:2.7Ghz intel core i7
-Memory 4GB 1333 Mhz DDR3
nah ane make udah sekitar 4 bulan awal beli masih pake snow leopard dan sekarang udah di upgrade jadi lion yg terbaru deh. bisa di bilang setelah upgrade ke lion semua jadi lumayan ngelag apa lagi buka program seperti
-Microsoft Office
-I movie
-Garage Band
Semoga Agan ber Baik hati Ngasih
Jangan Lupa Yah Gan
Kalo menurut ane 4gb cukup sih buat itunes , safari sama skype yg laen kecuali yg ane sebutin di atas nah ini ane mau sharing info kalo ada agan2 yg penasaran kaya ane buat upgrading macbook agan ke 8gb dan seberapa bedanya.
Langsung ke KTPQuote:
How to upgrade ?Quote:
[youtube]sCV4ijq9VHQ&feature;[/youtube]
Quote:
Removing or installing memory
Warning: The internal components of your MacBook Pro can be warm. If you have been using your MacBook Pro, wait ten minutes after shutting down the computer to let the internal components cool before continuing.
Step 1: Remove the bottom case
Shut down your MacBook Pro. Disconnect the power adapter, Ethernet cable, USB cables, security lock, and any other cables connected to the MacBook Pro to prevent damaging the computer.
Turn over your MacBook Pro and remove the ten (10) screws that secure the bottom case. Because the screws are different lengths, note the screw lengths and locations so you can replace the screws correctly. Put them aside in a safe place. Lift off the case and place it to the side.
Touch a metal surface inside the computer to discharge any static electricity from your body.
Step 2: Remove existing memory (if present)
Push the levers on the sides of the memory module in an outward direction to release the module from the memory card slot. The memory pops up at an angle. Before removing it, make sure you find the half-circle notches. If you dont, try pressing the levers outward again.
Hold the memory module by its notches and remove it from the slot.
Remove the other memory module.
Important: Hold the memory modules by their edges, and do not touch the gold connectors.
Step 3: Install memory
Align the notch on the gold edge of the module with the notch in the lower memory slot.
Tilt the card and push the memory into the slot.
Use two fingers with firm, even pressure to push down on the memory module. There should be a click when you insert the memory correctly.
Repeat this procedure to install an additional memory module in the top slot. Press down on the module to make sure it is level.
Note: Make sure you install the memory according to this illustration, with the gold contacts inserted almost completely into the connector.
Step 4: Replace the bottom case
Replace the bottom case. Replace and tighten the ten screws you removed earlier, making sure to put the different length screws in their proper locations.
